Wednesday 13 November 2013

FDA's Inspectional Objectives for CAPA Procedure


 
 
FDA's Inspectional Objectives for CAPA Procedure
 

 

 
 
CAPA is an excellent quality improvement tool, which evidently contributed a lower error rate in pharmaceutical industry. CAPA effectively tackle deviations and errors in the manufacturing process as well as quality deficiencies later on in the life cycle of products by avoiding future failures.
 
 

 
During quality system inspection FDA inspectors are much focused on CAPA effectiveness, because it is linked to so many other things like

·       Non conformances

·       Deviations

·       Market Complaints

·       Audits

·       Annual Product Review

·       Process improvement projects

·       Risk Management  etc.

 
FDA’s inspectional objectives on CAPA are detailed below.
 Inspectional Objectives

1. Verify that CAPA system procedure(s) that address the requirements of the quality system regulation have been defined and documented.
 
2. Determine if appropriate sources of product and quality problems have been identified. Confirm that data from these sources are analyzed to identify existing product and quality problems that may require corrective action.
 
3. Determine if sources of product and quality information that may show unfavorable trends have been identified. Confirm that data from these sources are analyzed to identify potential product and quality problems that may require preventive action.
 
4. Challenge the quality data information system. Verify that the data received by the CAPA system are complete, accurate and timely.
 
5. Verify that appropriate statistical methods are employed (where necessary) to detect recurring quality problems. Determine if results of analyses are compared across different data sources to identify and develop the extent of product and quality problems.
 
6. Determine if failure investigation procedures are followed. Determine if the degree to which a quality problem or nonconforming product is investigated is commensurate with the significance and risk of the nonconformity. Determine if failure investigations are conducted to determine root cause (where possible). Verify that there is control for preventing distribution of nonconforming product.
 
7. Determine if appropriate actions have been taken for significant product and quality problems identified from data sources.
 
8. Determine if corrective and preventive actions were effective and verified or validated prior to implementation. Confirm that corrective and preventive actions do not adversely affect the finished device.
 
9. Verify that corrective and preventive actions for product and quality problems were implemented and documented.
 
10. Determine if information regarding nonconforming product and quality problems and corrective and preventive actions has been properly disseminated, including dissemination for management review.
 

Poor CAPA systems remain one of the top problem areas for both the drug and device industries when it comes to FDA inspections. 

 The FDA really wants you to do three things. If you did
these three things you would fulfil most FDA regulations
and be in good standing with them:

1. Find your problems

2. Fix you problems

3. Prevent your problems

 
 

2 comments: